Marianne Cabrera Table July 08th, 2018 - 07:03:54
The most traditional head table arrangement is a long rectangle, with the bride and groom in the center. The bride and groom are flanked by their entire bridal party going down the table on either side of them. The arrangement is usually to have the best man seated beside the bride and the maid of honor next to the groom. From there, the rest of the bridesmaids and groomsmen are seated, alternating male/female. By the way, I have heard some people asking if it would be appropriate to place the bridesmaid and groomsmen gifts at each place setting at the head table. The answer is no; give your groomsmen and bridesmaid gifts a day or two before the wedding, and give each member of your bridal party the same wedding favor as the rest of your guests.
Large wicker picnic hampers can also work in this way too, although they do not provide a very uniform top surface. They do though look stylish, particularly when aged.
A final head table idea is for the bride and groom to sit at a table with their parents, the maid of honor and best man, and the spouses or dates of the honor attendants. This can be an excellent idea for a couple who has a very small wedding party or an unmanageably large one (the rest of the bridal party would sit among the other guests). It is also a very nice way to honor the parents of the bride and groom. This can be a lovely head table, as long as the newlyweds do not have a complicated family situation (ie, hostile parents or step-parents).
Dining: Have you ever invited guests over for dinner and then realised that you don't have enough space to seat them all? Your dining table just isn't big enough, or you don't even own one? Well, a trestle table can solve that problem. It can easily be used to increase your dining space. A four foot table can seat four to six people, and a six foot table can seat six to eight. And if you have a dining table too, these seats can be extra.
Once the overall look has been achieved, work can then begin on a finished version. Measurements must be taken and angles must be figured. There is a lot of math involved. Now each individual piece of steel can be cut and precisely fit to another. All connecting points must be hand welded and each weld must be hand ground. The last step is a chemical oxidation process to turn the steel either brown or black and then a few coats of clear paint are applied to protect the colored finish.
Once a three-dimensional prototype is created, the design can then be refined. The prototype allows you to view the tables from all angles and fine tune the spacing of the steel round-bar. The number of pieces used to build the table can also be changed. Sometimes additional pieces need to be added either for functional stability or from a design standpoint. Sometimes I remove pieces to open up the design.